ar many removable layers of clothing, and always be sure the outermost layer is 100% waterproof. Also, always wear goggles. Visibility and eye protection is very important.Second, before hopping on the lift, you should become familiar with the parts of the snowboard. Always wear the right size boots, and make sure they support on your ankles. Wearing boots that are too tight can leave you with sore ankles or chin splints. After choosing the perfect boot, consider your choice of binding. The bindings are what clip your boots to the board. There are two different types of bindings. The clipping binding has a calf support in the back, and has two clips that snap around your boot. This type of binding is the safest. The other type of binding, the step-in, is made to just step directly on the board. This one has no safely clip or back support. It is less of a hassle, but most people do not feel as safe in them. I suggest the clipping binding, because I feel the extra support on my calves gives me more control. Once you have decided on the binding, choose your board. Snowboards are made customized. They vary in length and weight depending on the size and height of the rider. The snowboard is measured in inches. Children ride between a 38”-43”. Women usually ride between 45”-53. For men, the sizes can run from 55”-65”. After choosing all the proper equipment, it is now time to approach the lift. The lift assistant will line you into the path of the chair. Lean back as you feel the chair picking you up. Grasp the handlebars of the chair as it lifts you. Failure to do this will cause you to fall off and you could get ran over by the chair (This knowledge comes from a very humiliating personal experience). The ride on the lift takes about five to ten minutes, but this depends on which run you choose. As you approach the end of the lift, it is advised to signal the assistant to slow the l...
